3D Printing Calculators

Estimate filament usage, print time, and costs for your 3D printing projects.

A 3D print costs three things — filament, machine-hours, and electricity — and only the first is obvious. Filament price per spool, print time from the slicer, and your local power rate together set the real cost of a part, and running a farm on thin margins hides it. These calculators combine material and time inputs into a per-print cost so pricing and batch decisions rest on numbers rather than a guess.

Material cost comes from the part’s volume and the density of the polymer; the calculators convert grams of filament to meters by filament diameter and price it from your spool cost. Time feeds both the electricity line and the throughput of a printer you are running as a business.

From grams to meters to dollars

A spool is sold by weight but used by length, so cost per gram is the number that matters. Price the spool by its weight (for example a $20 kg spool at $20 is $0.02 per gram), then multiply by the grams your slicer reports.

Fill density, wall count, and support volume swing grams more than any other setting. A part printed at 15 percent infill can use well under half the material of the same part at solid, so the material estimate should follow the actual slicer output.

Time, power, and the marginal print

Electricity cost is printer wattage × print hours × your $/kWh rate. Most hobby printers draw on the order of 100–200 W while printing, so long jobs add a small but real line that grows with throughput.

For a print farm, the binding cost is machine-hours: a 12-hour job occupies a slot regardless of its filament. Including a per-hour overhead in the calculation turns “is this profitable?” into a single comparison.

Quick reference

Cost per gramSpool price ÷ spool weight = material unit cost
Typical draw~100–200 W while printing (larger/ heated-bed jobs higher)
ElectricityWatts × hours ÷ 1000 × $/kWh
Infill effectFill % and supports dominate total grams

Frequently asked questions

Should I charge for failed prints?

If you run jobs at scale, amortize a first-failure rate into cost by marking material and time up for the fraction of prints that fail. Single one-off prints can skip this.

What is the point of the electricity number?

On one part it looks trivial; on a farm running dozens of multi-hour jobs a week it is a recurring line item, and including it prevents you from underpricing long, low-material prints.

How accurate is the material estimate?

It is only as good as the grams you enter — use the slicer’s reported material, not a theoretical volume, because supports and adhesion patterns change real usage.